Type K Thermocouple Temperature Sensor
CA$31.00
Thermocouple for Dyzend-X hotend
Out of stock
Thermocouple is preconfigured in most firmware, but you will need the proper amplifier board to run it.
Related products
-
PT100 Amplifier Board
CA$36.00 – CA$41.00Connect a PT100 temperature sensor to your 3d printer controller using this circuit. Amplifies the signal from the PT100Â to a voltage level that your printer can interpret precisely.
Connect a PT100 temperature sensor to your 3d printer controller using this circuit. Amplifies the signal from the PT100Â to a voltage level that your printer can interpret precisely.
-
PTFE tube 4mm X 3mm
CA$1.004mm OD x 3mm ID PTFE Tubing for 3D Printer and Dyze Design’s Hotend and accessories.
4mm OD x 3mm ID PTFE Tubing for 3D Printer and Dyze Design’s Hotend and accessories.
-
PushFit – 4mm Tube Through
Rated 1.00 out of 5CA$5.00M8x1.25 PushFit for 4mm OD tubing
M8x1.25 PushFit for 4mm OD tubing
Reviews
There are no reviews yet.