DyzeXtruder GT/Pro Motor
Rated 3.50 out of 5 based on 2 customer ratings
(2 customer reviews)
CA$28.00
Motor replacement for DyzeXtruder GT and DyzeXtruder Pro extruders.
Strong gear
The heat treated steel gear is press-fit on the motor shaft
Connector
Easy maintenance and cable management with the motor connector
5.5V
Rated Voltage
1A
Rated Current
PH-06AWJ
Connector Type
- DyzeXtruder GT Motor
Gear
The gear is assembled and comes with the motor
Cable
The cable is not included
2 reviews for DyzeXtruder GT/Pro Motor
Add a review Cancel reply
Related products
-
Tungsten Carbide Nozzle Kit
Rated 5.00 out of 5CA$245.00Full set of tungsten carbide nozzles for 3d printer hotends. The pack comes with 4 different nozzle sizes. All crafted in tungsten carbide and adapts for all type of filament.
Full set of tungsten carbide nozzles for 3d printer hotends. The pack comes with 4 different nozzle sizes. All crafted in tungsten carbide and adapts for all type of filament.
-
Nozzle Kit
CA$136.00Hard Stainless steel hotend’s Nozzle kit for all type of filament
Hard Stainless steel hotend’s Nozzle kit for all type of filament
-
Filament Sentinel Circuit Board
CA$17.00Circuit Board replacement for the Sentinelâ„¢ filament detector.
Circuit Board replacement for the Sentinelâ„¢ filament detector.
Christopher Castro (verified owner) –
Motor woks great and is quite powerful.
Charles Waldie (verified owner) –
This sucker gets way too hot fast. It causes a major heat creep during prints. I have followed all directions and setup with stepper 2209’s. I am just about to give up on this.