Type K Thermocouple Temperature Sensor
CA$33.00
Thermocouple for Dyzend-X hotend
Thermocouple is preconfigured in most firmware, but you will need the proper amplifier board to run it.
Related products
-
Individual Nozzles
Price range: CA$28.00 through CA$37.00Hard Stainless steel hotend’s Nozzle for all type of filament
-
PT100 Amplifier Board
Price range: CA$38.00 through CA$43.00Connect a PT100 temperature sensor to your 3d printer controller using this circuit. Amplifies the signal from the PT100 to a voltage level that your printer can interpret precisely.
Reviews
There are no reviews yet.