High Temperature and Fast print 3d printer hotend.
The aluminum melt block transfer heat very quickly to the nozzle for an efficient and very fast printing speed. Furthermore, the long melt zone can handle very high filament feed without any trouble.
A titanium alloy has been meticulously chosen to provide both stiffness and low thermal conductivity, limiting heat losses to the cold side.
The high temperature sensor used inside the DyzEnd-X enable precise readings up to 500°C. Any thermoplastics can be used with the DyzEnd-X.
The heated zone is made entirely from metals which can withstand very high temperature before losing mechanical properties. Even the sensors and heaters are protected by high temperature resistant sleeves.
The DyzEnd-X comes built in with high wear resistant nozzle. The performance have been measured and tested.
By using a very special high temperature sealing washer, the DyzEnd-X is able to switch nozzles at room temperature. No leaks, no burning hazard.
The filament is very well guided inside the DyzEnd-X, which allows very high speed with flexible filament.
The DyzEnd-X perform very well in retraction. The secret is its manufacturing process which enable very low friction inside the tube.
The unique high temperature sensor has a resolution of 0.16°C at 210°C which is better than a amplified RTD sensor and a thermocouple.
The DyzEnd-X is a high-end product and comes preassembled and tested avoiding the user to have any trouble receiving substandard part that are hard to assemble or fit together.
The DyzEnd-X comes with connectors for each electrical component so you can easily maintain it.
The sealing washer ensure a leak-free operation and makes it easier to switch nozzles.
The DyzEnd-X can be easily converted to a liquid cooled setup with Dyze Design’s specialized cooling blocks.
The DyzEnd-X is compatible with a M8x1.25 push to connect fitting. The 4mm PTFE tube can be inserted through the connector and guides the filament as far as possible inside the hotend.
The hotend mounting mechanism is based on the form factor called “Groove Mount”. The 12mm groove makes it very easy to switch and maintain your hotend and nozzle.
The sensor is installed with elegance using a brass housing. This ensure every hotend read the temperature properly without any variation caused by assembly.
By using a low conductivity transition tube, the DyzEnd-X is designed very small. This enables you to use your build volume more efficiently.
The DyzEnd-X can heat very quickly. In only 70 seconds, it reaches 210°C.
The unique serial engraved on each hotend protects the product against clones. Also, it assures a tracking of suppliers, assembly and quality reports.
The DyzEND-X prints all types of plastics:
|Weight – Hotend||52||g|
|Operating Voltage||12, 24||V|
|Operating temperature||0 to +70||°C|
|Thermistor resistance at 25°C (500°C)||4700||kΩ|
|Thermistor resistance at 200°C (500°C)||8||kΩ|
|Maximum temperature – 40W||420||°C|
|Maximum temperature – 60W||500||°C|
Free shipping on all domestic and international orders over $1000 USD! Dismiss