Type K Thermocouple Temperature Sensor
CA$31.00
Thermocouple for Dyzend-X hotend
Out of stock
Thermocouple is preconfigured in most firmware, but you will need the proper amplifier board to run it.
Be the first to review “Type K Thermocouple Temperature Sensor” Cancel reply
Related products
-
PushFit – 6mm Tube Through
CA$7.00M8x1.25 PushFit for 6mm OD tubing
M8x1.25 PushFit for 6mm OD tubing
-
PT100 Amplifier Board
CA$36.00 – CA$41.00Connect a PT100 temperature sensor to your 3d printer controller using this circuit. Amplifies the signal from the PT100Â to a voltage level that your printer can interpret precisely.
Connect a PT100 temperature sensor to your 3d printer controller using this circuit. Amplifies the signal from the PT100Â to a voltage level that your printer can interpret precisely.
- Select options
Reviews
There are no reviews yet.