Hotends

Hotends

How can I setup and install my new DyzEnd-X Hotend ?


1DyzEND-X Assembly 2Firmware 3Slicer 4Final adjustments 5Cooling 6Setup for Bowden Step 1: DyzEND-X Assembly 1Insert the heater cartridge in the heater block. 2Tighten the screw: Tighten the M3 flat heat screw...

How can I setup and install my new DyzEnd Hotend ?


1DyzEND Assembly 2Firmware 3Slicer 4Final adjustments 5Cooling 6Setup for Bowden Step 1: DyzEND Assembly 1Insert the heater cartridge in the heater block. Add the M4x6 screw. Tighten using 3 mm Allen Key. 2Bend...

How to change the nozzle on my DyzEnd or DyzEnd-X Hotend ?


Do not try to change your nozzle while the hotend is installed. Always remove it from your printer before changing your nozzle. DyzEnd Step 1: Use a Wrench Install the hotend in an adjustable...

How to clean my DyzEnd or DyzEnd-X Hotend ?


DyzEnd and DyzEnd-X are very easy to clean and takes only a few minutes. It is very important to keep the sealing junction clean to avoid any leaks. After each nozzle change, make sure the entire inside is clean. If it is not the case,...

My filament is jammed or my nozzle is clogged


This can happen if the nozzle is clogged or if the filament is stuck inside the thermal transition tube. Here are some steps you may follow in order to solve this problem: Clean the nozzle orifice Insert any pin that...

$15 Flat Rate Shipping for USA & Canada - Worldwide Free Shipping over $500* Dismiss

X