Liquid cool your DyzEnd or DyzEnd-X

1

Remove the fan

Use a 2mm allen wrench and remove the 4 screws holding the fan.
2

Apply thermal paste

Apply thermal paste on your heatsink.
3

Install the liquid cooling block

Use a 2mm allen wrench and install the 4 screws holding the liquid cooling block.

Make sure to remove the tape under the liquid cooling block before installing it! Do not over-tighten the screws.

4

Install the tubing

Install your tubes inside the loop. There is no specific input or output on the liquid cooling block. Do not forget to install the hose clamps if your loop is already completed on the other end.
5

Crimp the tube clamps

Use a tube crimping plier and crimp the hose clamps.

Leave a Reply

Your email address will not be published. Required fields are marked *